STM32 Starter Kit with OLED, Sensors & ST-Link V2

The STM32 Starter Kit is a beginner kit for learning ARM Cortex-M microcontrollers on real hardware. It pairs an STM32F103C8T6 "Blue Pill" board with an ST-Link V2 programmer/debugger, a 0.96-inch OLED, sensors and a breadboard, so you can flash, debug and test code from your first day.

What's in the box

1. STM32F103C8T6 "Blue Pill" development board
2. ST-Link V2 programmer/debugger
3. Small breadboard
4. 0.96-inch OLED display (128x64)
5. DHT11 temperature and humidity sensor
6. PIR motion sensor
7. IR obstacle sensor
8. Flame sensor
9. LDR (light sensor) module
10. Buzzer module
11. Single-digit 7-segment display
12. RGB LED
13. LEDs: 5 red, 5 yellow, 5 green
14. 6 push buttons
15. 3 potentiometers
16. Resistors: 220 Ω, 330 Ω, 1 kΩ, 10 kΩ
17. Jumper cables
18. 40-pin header
19. Resistor colour code card
20. Storage box
21. E-book tutorial

What you can build with this kit

• Temperature and humidity monitor: DHT11 readings on the OLED.
• Motion alarm: the PIR sensor triggers the buzzer and an LED.
• Traffic light controller: red, yellow and green LEDs with timed sequences.
• Light-level meter: read the LDR through the ADC and show the value on the OLED.
• Fire alarm: the flame sensor drives the buzzer.
• Push-button counter: count presses on the 7-segment display.

How to get started

Install STM32CubeIDE (free). Connect the ST-Link V2 to the Blue Pill's SWD pins (3.3V, SWDIO, SWCLK, GND), then build and flash your first LED blink program. The e-book tutorial walks through each project.

Tip: the STM32 runs at 3.3 V logic. Power the sensors from 3.3 V where they support it, and don't drive STM32 inputs with 5 V signals unless that pin is 5 V tolerant.

Why learn on STM32?

STM32 microcontrollers are used widely in industrial and consumer products. Learning with an ST-Link debugger teaches the same flash-and-debug workflow used in professional embedded work, which an Arduino-style USB upload does not.

Frequently asked questions

Do I need a separate programmer?

No. The ST-Link V2 is included.

Which software can I use?

STM32CubeIDE, Keil µVision or IAR. STM32CubeIDE is free.

Is this kit suitable for beginners?

Yes, if you know basic C. If you have never programmed a microcontroller, start with an Uno R3 starter kit and move to STM32 next.

Buying from Anu Electronics

Sold by Anu Electronics, Chennai, with shipping across India. For college lab or bulk orders, WhatsApp +91 93454 49314 or email info@anuelectronics.com.